Weber 1200 owner manual Add fuel scale assembly, Install igniter

Step 11

Add fuel scale assembly

You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers.

Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame.

Add washers then wing nuts and tighten. Figure 13.

Step 12

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

Route the igniter and wires as shown. Figure 14 (a). Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 14 (b). Loosen the igniter lock nut and slide the igniter to the small part of the keyhole. Figure 14 (c). Tighten the igniter lock nut.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

E

(a)

	E
	F
	F
		(b)
View from front left		View from front right
	Figure 13	Figure 14

(c)

Keyhole in frame brace

Igniter lock nut

Frame brace	Small part of keyhole
	in frame brace

15