Weber 2200 Series manual Fill LP tank, Remove control panel, Check that items are secured

Step 10

Fill LP tank

Note - The LP tank manufacturer is responsible for the materials, workmanship and performance of the tank. If the tank has a defect, malfunctions, or you have a question regarding the tank, call the tank manufacturer's customer service center. The phone number is on the warning decal which is permanently attached to the tank. If the tank manufacturer has not resolved the issue to your satisfaction, then call Weber-Stephen Products Co., Customer Service Center.

Take the LP tank to an RV center (or some other source of LP gas) to fill the tank with 20 pounds of liquid propane.

WARNING: We recommend that your LP tank be filled at an authorized LP gas dealer by a qualified attendant, who fills the tank by weight.

IMPROPER FILLING IS DANGEROUS.

Tell your LP dealer that this is a new LP tank. The air must be removed from a new LP tank before the initial filling. Your LP tank dealer is equipped to do this.

CAUTION: If you exchange your LP tank, make sure you get a similar tank in return. Your LP tank is equipped with a quick-disconnect valve. Other LP tanks are not compatible with your barbecue connection.

The LP tank must be installed, transported and stored in an upright position. LP tank should not be dropped or handled roughly.

Never store or transport the LP tank where temperatures can reach 125° Fahrenheit (too hot to hold by hand – for example: do not leave the LP tank in a car on a hot day).

For full instructions on safe handling of LP tanks, see Section "Safe handling tips for LP gas,” in the Operating Guide.

Step 11

Remove control panel

Remove the right side work table. Remove the burner control knobs. Figure 13 (a). Grasp the under the edge of the control panel at the control panel push-in buttons and slide along the frame toward you. Figure 13 (b). Lift off the control panel.

(a)

control panel push-in

buttons

(b)

Figure 13

Step 12

Check that items are secured

Note - Although the following items were factory assembled, check that they have not loosened during shipping and handling.

Remove the tape from the manifold bracket.

Check that the bracket is securely hooked onto the frame brace and under the manifold at the center burner valve. Figure 14.

If it is loose lift the bracket, manifold and cooking box slightly as a unit and reposition onto the frame brace.

Manifold Bracket

Manifold Bracket

6 Figure 14