Step 7
Install side burner locks
Note: The locks are taped to the inside of the side burner lid
You will need: frame assembly, two side burner locks and a 7/16 inch wrench.
Turn frame assembly right side up.
Loosen the right rear 1/4 x 20 bolt. Install the side burner lock. The “U” shape cut out of the lock slips down over the bolt. Tighten with a wrench. Figure 6 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock fits between the front panel and the frame. The “U” shape cut out slips up over the bolt. Tighten with a wrench.
(a)
(b)
Figure 6
Step 8
Add cooking box
You will need: frame assembly, cooking box assembly, 1/4- 20 x 2 inch bolt, 1/4 inch nylon washer,
Uncoil the hose.
Set the cooking box into the frame so the burner tubes are under the frame brace. Figure 7.
Burner tubes
Frame brace
Figure 7
Slide the cooking box to the left within the frame. Put the washer on the bolt. Insert the bolt through the cooking box and frame with the head of the bolt outside the box. Figure 8. Add keps nut. Tighten by holding the bolt with pliers while you tighten the nut with the 7/16 inch wrench.
Figure 8
Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment:
a)Do the valves fit into the ends of the burners? Figure 9 (a).
b)Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 9 (b).
c)Are the wing nuts under the burner assembly hand tight? Do not tighten with pliers. Figure 9 (c).
If you answered YES to a, b and c, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact
Guide screw
(b)
(a)
(c)
Figure 9
Wing nuts
12
