Weber #43028 manual GAS Instructions

	GAS INSTRUCTIONS	13
CHECK FOR GAS LEAKS		(1)
	DANGER
Do not use an open flame to check for gas leaks. Be
sure there are no sparks or open flames in the area
while you check for leaks. Sparks or open flames will
result in a fire or explosion, which can cause serious
bodily injury or death and damage to property.
	WARNING: You should check for gas leaks every time	(2)
	you disconnect and reconnect a gas fitting.
Note - All factory-made connections have been thoroughly checked for gas
leaks. The burner has been flame-tested. As a safety precaution however,
you should recheck all fittings for leaks before using your Weber® Gas Fire-
place. Shipping and handling may loosen or damage a gas fitting.
	WARNING: Perform these leak checks even if your
	fireplace was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Note - Since some leak test solutions, including soap and water, may be		(3)
slightly corrosive, all connections should be rinsed with water after checking
for leaks.
To perform leak checks: open cylinder valve by turning the cylinder valve
hand-wheel counterclockwise.
	WARNING: Do not ignite burner when leak checking.
Check for leaks by wetting the connections with the soap and water solution
and watching for bubbles. If bubbles form or if a bubble grows, there is a
leak.
Check:		(4)
1) Regulator-to-Cylinder connection.
	WARNING: If there is a leak at connection (1) or (2),
	retighten the fitting by hand only, and recheck for
	leaks with soap and water solution. If a leak persists
	after retightening the fitting, turn OFF the gas. DO
	NOT OPERATE THE FIREPLACE. Contact the Customer
	Service Representative in your area using the contact
	information on our web site. Log onto www.weber.com®.
Check:
2)	Hose-to-regulator.
3) Hose to bulkhead fi tting.
4)	Bulkhead fi tting.

WARNING: If there is a leak at connections (2), (3), or (4), turn OFF the gas. DO NOT OPERATE THE FIREPLACE. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber. com®.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.