18 | TROUBLESHOOTING | ||||
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| PROBLEM |
| CHECK | CURE |
|
| Burner burns with a dark orange |
| Inspect Spider / Insect Screen for pos- | Clean Spider / Insect Screen. (See Section | |
| flame, in conjunction with heavy soot- | sible obstructions. (Blockage of holes.) | “Annual Maintenance”) | ||
| ing. |
|
|
|
|
|
|
|
|
| |
| Burner does not light. | The excess fl ow safety device, which is | To reset the excess fl ow safety device turn all | ||
| a small flickering flame in the HIGH |
| part of the fi replace to cylinder connec- | burner control knobs and the cylinder valve | |
| position. |
| tion, may have activated. | OFF. Disconnect the regulator from the cylin- | |
|
|
|
| der. Turn burner control knobs to HIGH. Wait | |
|
|
|
| at least 1 minute. Turn burner control knobs | |
|
|
|
| OFF. Reconnect the regulator to the cylinder. | |
|
|
|
| Turn cylinder valve on slowly. Refer to “Light- | |
|
|
|
| ing Instructions”. | |
|
|
|
|
| |
| Burner does not light, or flame is low | Is LP fuel low or empty? | Refi ll LP cylinder. | ||
| in HIGH position. |
|
|
|
|
|
| Is fuel hose bent or kinked? | Straighten fuel hose. | ||
|
|
| |||
|
|
|
|
|
|
|
|
| Is igniter functioning properly? | Replace igniter (see contact info. below). | |
|
|
|
|
|
|
|
|
| Is the igniter box blocked? | Remove obstructions from igniter box (see | |
|
|
|
| pg. 10, Step 11 of “Assembly” Section). | |
|
|
|
|
|
|
| Flame seems to lose heat when |
| Is there frost/ice on the outside of | Turn off burner control knobs and | |
| burning in cold weather temperatures | the LP cylinder? | the LP cylinder. Replace with a | ||
| 50° F or colder. (The liquid propane in |
| spare LP cylinder and resume | ||
| the cylinder turns to vapor too slowly |
| burning. | ||
| to supply the burners with gas. This is |
| WARNING: The spare or | ||
| due to the air temperature cooling the |
| disconnected LP cylinder must | ||
| LP cylinder which slows the |
|
| be stored outdoors in a well | |
| vaporization process.) |
|
| ventilated area out of the reach | |
|
|
|
| of children. | |
|
|
|
|
| |
| Burner flame pattern is erratic. Flame | Are burner holes blocked? | Clean burner holes. (See Maintenance Sec- | ||
| is low when burner is on HIGH. Flames |
| tion.) | ||
| do not ignite all burner holes. |
|
|
|
|
|
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
