Weber #43028 manual Operating Instructions, Manual Lighting

OPERATING INSTRUCTIONS			17
MANUAL LIGHTING
1) Remove the rain shields.	1.
DANGER
Failure to remove rain shields while igniting the
fireplace’s burners, or not waiting 5 minutes to allow
the gas to clear if the fireplace does not light, may			4.	6.
result in an explosive flame-up which can cause
serious bodily injury or death.
2) Make sure the burner control knob is turned OFF. (Push knob down and	2.	5.
turn clockwise to ensure it is in the off position.)
WARNING: The burner control knob must be in the
OFF position before turning on the liquid propane
cylinder valve. If it is not in the OFF position, when
you turn on the LP cylinder valve, the “excess gas
flow control” feature will activate, limiting the flow
of gas from the LP cylinder. If this should occur, turn
OFF the LP tank valve and burner control knob. Then
start over.
DANGER				3.
When the “excess gas flow control” feature is
activated, a small amount of gas is still flowing to the
burner. After turning OFF the cylinder and burner
control knob, wait at least 5 minutes for the gas to
clear before attempting to light the fireplace. Failure to
do so may result in an explosive flame-up, which can
cause serious bodily injury or death.

3)Turn the cylinder on by turning the cylinder valve counterclockwise.

4)Insert match holder with lit match near the center of the burner area.

WARNING: Do not lean over open fireplace.

5)Push burner control knob down and turn to START/HI.

6)Make sure that the burner is lit.

TO EXTINGUISH

Push in the burner control knob and turn clockwise to the OFF posi- tion. Turn gas supply OFF at the source. When unit has cooled, replace rain shields.

WARNING: If the burner does not light, turn the burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

Note: Normal burning pattern will develop light soot on log set. If heavy sooting occurs, refer to troubleshooting.