GAS INSTRUCTIONS
mWARNING: The gas connections of your Summit® gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your Summit® gas grill.
Remove Control Panel
Parts required: Phillips screwdriver and a towel..
A)Remove the burner control knobs (1)..
B)Open both doors and place a towel on top of the doors.. This will protect the control panel and tops of the doors from getting scratched on the next step..
C)Remove the screws from the underside of the control panel with a Phillips screwdriver (2)..
D)Tilt the conrol panel forward and lift up and away from the grill (3) (For Summit® models with LED features: Be careful not to break or disconnect the wires for the control panel LED’s)..
E)Place the control panel on the towel covering the door assemblies (4).. ◆
CHECK FOR GAS LEAKS
mDANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.
Note: All
mWARNING: The gas connections of your gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your gas grill.
mWARNING: Perform these leak checks even if your barbecue was dealer or store assembled.
If your grill has a side burner make sure the side burner is off..
To perform leak checks: open cylinder valve by turning the cylinder valve
mWARNING: Do not ignite burners when leak checking.
You will need: LP cylinder, a soap and water solution and a rag or brush to apply it..
A)Mix soap and water..
B)Turn on the cylinder valve..
C)Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles.. If bubbles form, or if a bubble grows, there is a leak..
If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck with the soap and water solution.
If leak does not stop do not use the barbecue. Contact the customer service representative in your area using the contact information on our web site. Log onto www.weber.com®.
D)When leak checking is complete, turn gas supply off at the source and rinse connections with water..
Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
1
The grill illustrated may have slight differences than the model purchased.
2 | 3 |
|
4
www.weber.com® 11
