Weber 89369 manual Sideburner Maintenance, Rotisserie Troubleshooting, Side Burner Maintenance

32 SIDEBURNER MAINTENANCE

SIDE BURNER MAINTENANCE

WARNING: All gas controls and supply valves should be in the “OFF” position.

Make sure black wire is connected between the igniter and electrode. Make sure white wire is connected between the igniter and grounding clip. Spark should be a white/blue color, not yellow.

1) Igniter Wire

2) Ground wire

3) Burner

Side Burner Grate

Side Burner cap

Side Burner Ring & Head

Igniter Electrode

Control Knob

Igniter

ROTISSERIE TROUBLESHOOTING

PROBLEM	CHECK	CURE
Rotisserie burner does not light.	Did you hold the burner control knob in and	Try to relight burner by holding burner control knob in and continue holding in until
	hold in for 20 seconds until after burner	20 seconds after burner has ignited.
	ignited?
	Did you wait to see the entire ceramic surface	When relighting burner by holding burner control knob in, wait to see the entire
	become alight before counting 20 seconds?	ceramic surface become alight before counting 20 seconds?
	Did you repeatedly use the snap ignition until	After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
	the burner ignited?	the burner ignites (refer to “Lighting the Rotisserie Burner”).
	Does the igniter work (Do you see a spark	Try manually lighting the burner (refer to “Lighting the Rotisserie Burner”). Call
	when you repeatedly use the snap igniter?	customer service.
General Symptoms:	The excess flow safety device, which is part of	To reset the excess flow safety device turn all burner control knobs and the cylinder
Burner does not light. -or- Burner has	the barbecue to cylinder connection, may have	valve to “OFF”. Disconnect the regulator from the cylinder. Turn burner control
a small flickering flame	activated.	knobs to “START/HI”. Wait at least 1 minute. Turn burner control knobs to “OFF”.
		Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to
		“Lighting Instructions”.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

WWW.WEBER.COM®