Weber S-460 manual LIGHTING THE SMOKER BURNER mDANGER

Models: S-460

1 32
Download 32 pages 15.69 Kb
Page 18
Image 18
LIGHTING THE SMOKER BURNER

18

operating Instructions

LIGHTING THE SMOKER BURNER

mDANGER

Failure to open the lid while igniting the grill, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.

Smoker Burner Snap Ignition

Note: The control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”. This will ignite the smoker burner.

mWARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

1)Open the grill lid.

2)Open smoker box lid.

3)Fill smoker with water soaked wood chunks or chips.

4)Make sure that all burner control knobs not being used are turned to “OFF”. (Push control knob in and turn clockwise to ensure that it is in the “OFF” position).

5)Turn on the gas at source.

mWARNING: Do not lean over the open grill while lighting.

6)Push the control knob in and turn to “START/HI” until you hear the igniter snap - continue to hold control knob in for two seconds. This action will spark the igniter, the burner lighting tube and then main burner.

7)Check that the burner is lit by looking through the cooking grates. You should see a flame. If burner does not light on first try, push control knob in and turn to OFF. Repeat lighting procedure a second time

1

 

7

2

 

3

 

8

4

6

 

* The grill illustrated may have slight differences

5

 

than the model purchased.

 

46

8)Close smoker cover after wood starts to smolder and turn control knob to “LOW”.

m DANGER

To Extinguish

 

If the smoker burner does not light, turn the burner control knob to “OFF” and wait 5 minutes to let the gas clear before attempting to light.

Push in and turn each burner control knob clockwise to “OFF” position. Turn gas supply off at the source.

www.weber.com®

Page 18
Image 18
Weber S-460 manual LIGHTING THE SMOKER BURNER mDANGER