Weber S-470TM Sear Burner Troubleshooting, Handle Light Troubleshooting, Problem, Check, Cure

26	SEAR BURNER TROUBLESHOOTING
PROBLEM	CHECK	CURE
Burners burn with a yellow or orange	Inspect Spider/Insect Screens for possible	Clean Spider/Insect Screens. (See Section “Annual Maintenance”)
flame, in conjunction with the smell	obstructions. (Blockage of holes.)
of gas (This is normal for the burner
lighting tube).
Sear Station burner does not light.	Did you ignite the two adjacent main burners	Verify adjacent main burner ignition by visual inspection of a flame.
	(See Sear Station burner lighting instructions	WARNING: If ignition does not occur in 5 seconds, turn burner control
	for safe lighting procedure)
		OFF, wait 5 minutes to let the gas clear before you try again
	Does Burner light with a match?	If you can light Burner with a match, then check the Crossover® Channel on the sear
		burner. (See Maintenance for burner removal and cleaning procedure.)
	Does the igniter work (Do you see a spark	Try manually lighting the burner (refer to “Lighting the Rotisserie Burner”). Call
	when you repeatedly use the snap igniter?	customer service.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

OPERATING THE HANDLE LIGHT

The Weber Grill Out™ Handle Light has a built-in “Tilt Sensor.” With the power button

(a) activated, the light will come on when the grill lid is open. The light will turn off when the lid is closed. For daytime use, deactivate the sensor by pressing power button (a).

HANDLE LIGHT TROUBLESHOOTING

PROBLEM	CHECK	CURE
Weber Grill Out™ Handle	Are the batteries old?	Replace batteries.
Light does not light.
	Are the batteries installed correctly?	See assembly illustration.
	Is the lid in the up position with the power button ON?	Light will activate when lid is open.
	Is the Weber Grill Out™ Handle Light activated?	Press the power button.
	Is the Weber Grill Out™ Handle Light positioned correctly on the handle?	Adjust position (See assembly illustration).

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

WWW.WEBER.COM®