Weed Eater 173487 Tractor -- Model Number Steering, To Adjust Mower Cutting Height, To Transport

Discharge Guard

Attachemnt

Lift Lever High Position

Low Position

Attachment Clutch Lever “Engaged” Position

TRACTOR -- MODEL NUMBER 259723

STEERING

38

63

11

39

1

41

42

37

37

36

6244

51

54

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•	Raise attachment lift to highest
	position with attachment lift control.
•	When pushing or towing your tractor,
	be sure gearshift lever is in neutral (N)
	position.

8	27		17
			18
			19	68	67	67
			46
23			8	47		67
	22		6	13
			9	65
11			2	85	46
					8
	66
			7	85	6
	40
	29		9		9
		79	5
						47
			80
		25
					7
			3	32	9
					5

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

•Select desired height of cut.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disen- gage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the discharge guard in place.

• Do not push or tow tractor at more than

five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is

	68	11
29	82

26

4

dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

		43
15
	40
15	29	43
	28	6
		8
15	10
	30

“Disengaged” Position

36 13