Weed Eater 545186765, 600 instruction manual Service And Adjustments, Replacing The Line

SRemove the wheel by pressing one of the buttons. Clean the wheel and groove on the motor housing with a soft brush. Reinstall wheel (see ASSEMBLY section).

Air Vents

Groove

SERVICE AND ADJUSTMENTS

REPLACING THE LINE

WARNING: Disconnect unit from power source before servicing.

1.Press and hold in the two cap release latches.

2.Pull cap away from the hub.

	Cap
	Cap
Spool	release
	latch

Hub

Eyelet

3.Remove old spool.

4.Clean entire surface of hub and spool.

5.Replace with a pre--wound spool or cut two lengths of 13 feet (4 meters) of 0.065″ (1.65 mm) diameter WEED EATER brand line. Use of heavier lines could overload and damage unit.

WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.

6.Insert one end of the line about 1/2 inch (1 cm) into one of the small holes in the up- per section of the inside of the spool.

7.Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool.

8.Push the line into the notch, leaving 3 to 5 inches (7 -- 12 cm) unwound.

9.Repeat on the lower section of the spool.

Notches

11