Weed Eater 952711866 Operating Instructions, Select AN Extension Cord, Correct Operating Position

OPERATING INSTRUCTIONS

Use only a voltage supply as specified on your unit.

SELECT AN EXTENSION CORD

Extension Cord Gauge Chart

Length of Cord		Gauge
25	Ft. (7.5 m)	18 Gauge
50	Ft. (15 m)	16 Gauge
100 Ft. (30 m)		16 Gauge

Extension cords are available for this unit.

ATTACH THE EXTENSION

CORD TO YOUR TRIMMER

Loop your extension cord through the handle and around the hook as shown. Insure the plug and cord are firmly and fully engaged.

Cord Retainer

Extension Cord

CORRECT OPERATING POSITION

TrimmingEdging

WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.

When operating unit, stand as shown and check for the following:

SWear eye protection and heavy clothing. S Hold trigger handle with right hand and as-

sist handle with left hand.

S Keep unit below waist level.

S Cut only from your right to your left to ensure debris is thrown away from you. Without bending over, keep line near and parallel to the ground (perpendicular when edging) and not crowded into material being cut.

ADVANCING THE CUTTING LINE

The cutting head advances line automati-

cally. Do not tap head on the ground to ad- vance line. This may break parts and cause cutting head to malfunction.

Upon unit start up, the line will advance auto- matically to the correct cutting path length. Always keep the shield in place when the tool is being operated.

WARNING: Use only 0.065 inch (1.65 mm) diameter round line. Other sizes and shapes of line will not advance properly and will result in improper cutting head func- tion or can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious injury. See page 2 for warning concerning other cutting devices.

TRIMMING

Hold the bottom of the trimmer head about 3 inches (8 cm) above the ground and at an an- gle. Allow only the tip of the line to make con- tact. Do not force trimmer line into work area.

Trimming

3 inches (8 cm) above ground

EDGING POSITION

While holding the trimmer in operating posi- tion, you can press this button and twist the lower portion 180_ clockwise for edging.

Button

EDGING

While edging allow the tip of the line to make contact. Do not force the line. The edge guard helps protect the unit and keeps the unit from contacting the ground. Take extra caution while edging as objects can be thrown from the trimmer line.

Edging

SCALPING

The scalping technique removes unwanted vegetation. Hold the bottom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow the tip of the line to strike the ground around trees, posts, monuments, etc. This technique increases line wear.

6