Trane LO manual Tracer ZN.010 Typical Wiring Diagram, For Reference Only

Tracer® ZN.010 Typical Wiring Diagram

NOTES:

1.UNLESS OTHERWISE NOTED, ALL SWITCHES ARE SHOWN AT 25 C (77 F), AT ATMOSPHERIC PRESSURE, AT 50% RELATIVE HUMIDITY, WITH ALL UTILITIES TURNED OFF, AND AFTER A NORMAL SHUTDOWN HAS OCCURRED.

2.DASHED LINES INDICATE RECOMMENDED FIELD WIRING BY OTHERS. DASHED LINE ENCLOSURES AND/OR DASHED DEVICE OUTLINES INDICATE COMPONENTS PROVIDED BY THE FIELD. SOLID LINES INDICATE WIRING BY TRANE CO.

3.NUMBERS ALONG THE RIGHT SIDE OF THE SCHEMATIC DESIGNATE THE LOCATION OF CONTACTS BY LINE NUMBER. AN UNDERLINED NUMBER INDICATES A NORMALLY CLOSED CONTACT.

4.ALL FIELD WIRING MUST BE IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC), STATE AND LOCAL REQUIREMENTS.DEVICE PREFIX

LOCATION GUIDE

AREA LOCATION

1CONTROL PANEL

2CONTROL END

3PIPING END

4FAN SECTION

5COIL SECTION

6CUSTOMER

For Reference Only:

This schematic shows typical wiring of a fan-coil. It is not intended for a basis of design or for equipment installation purposes in the field. For an as-built schematic specific to a particular unit, please see the ship-with schematic for that specific unit or contact your local Trane representative.

Two-pipe autochangeover

Two-position N/C control valve

Two-position N/C fresh air damper actuator

EWT sensor

Condensate overflow detection

Low temperature detection

Unit mounted fan mode switch and setpoint dial

Return air temperature sensor

130 UNT-IOM-6