Tracer® ZN.010

and ZN.510

Manual Output Test

Manual Output Test Procedure

The purpose of the manual output test sequence is to verify output and end device operation. Use the manual output test to:

·Verify output wiring and operation without using Rover™, service tool.

·Force the water valve to open and balance the hydronic system.

Note: The manual output test is not an automatic cycle. You must press the Test button to proceed through each step.

The controller observes all diagnostics that occur during the test sequence. Although an automatic diagnostic reset sequence exists as part of the controller’s normal operation, the automatic diagnostic reset feature is not active during the test sequence.

If left in an individual test step, the controller remains in test mode for 60 minutes and then exits to normal operation.

Many service calls are due to unit diagnostics. The test sequence resets unit diagnostics and attempts to restore normal unit operation prior to testing the outputs. If the diagnostics remain after a reset, the STATUS LED indicates the diagnostic condition is still present (two blinks). See the Green STATUS LED section in Table 11 on page 47.

Follow the procedure below to test the Tracer® ZN.010 and ZN.510 controller.

1.Press and hold the Test button for at least two seconds (not exceeding 5 seconds), and then release, to start the test mode.

2.The test sequence will turn off all outputs and then attempt to clear all diagnostics.

3.Press the Test button several more times (no more than once per second) to advance through the test sequence.

The outputs are not subject to minimum times during the test se- quence. However, the test sequence only permits one step per

second which limits minimum output time.

The green LED is turned off when the Test button is pressed. To begin the manual output test mode, press and hold the Test button (turning off the green LED) for at least two seconds.The green LED will begin to blink, indicating the controller is in test mode.

48

UNT-IOM-6

Page 48
Image 48
Trane LO manual Manual Output Test Procedure

LO specifications

Trane LO is a cutting-edge solution in the HVAC sector, designed with advanced engineering and smart technologies to meet diverse climate control needs. Renowned for its reliability and efficiency, Trane LO offers a wide array of features that set it apart in the market.

One of the core characteristics of Trane LO is its energy efficiency. Equipped with variable speed compressors, the system can adjust its output according to the cooling or heating demand, ensuring optimal energy use. This feature not only reduces energy consumption but also lowers utility bills for users. Additionally, Trane LO units often come with a SEER (Seasonal Energy Efficiency Ratio) rating that ensures top performance during hotter months.

Incorporating state-of-the-art technology, Trane LO features Smart Technology integration. Through IoT (Internet of Things) capabilities, users can monitor and control their HVAC systems remotely via smartphones or smart home devices. This feature promotes convenience and ensures that energy use can be optimized from anywhere, giving users greater control over their indoor climate.

Another standout technology in Trane LO is its use of environmentally friendly refrigerants. The system is designed to utilize low-GWP (Global Warming Potential) refrigerants, making it compliant with modern environmental standards and contributing to a greener planet.

The Trane LO also emphasizes durability. Constructed with high-quality materials, including weather-resistant finishes, these units are built to withstand various environmental conditions, ensuring they maintain peak performance over the years.

Noise reduction is another critical aspect of the Trane LO line. With features such as sound blankets and vibration dampening technology, the units operate quietly, ensuring that the comfort of users is not compromised by disruptive noise levels.

Maintenance is simplified with the Trane LO, as several units are engineered for easy access to essential components, promoting hassle-free servicing. This is vital for prolonging the lifespan of the system and reducing maintenance costs.

In summary, Trane LO represents a fusion of energy efficiency, advanced technology, environmental responsibility, durability, and user-friendly features. Whether for residential or commercial applications, Trane LO systems stand as a reliable choice for effective climate control.