Trane LO manual Tracer ZN.010 Typical Wiring Diagram, For Reference Only

Tracer® ZN.010 Typical Wiring Diagram

			NOTES:
			1. UNLESS OTHERWISE NOTED, ALL
	LEGEND		SWITCHES ARE SHOWN AT 25 C (77 F),
			AT ATMOSPHERIC PRESSURE, AT 50%
DEVICE		LINE
			RELATIVE HUMIDITY, WITH ALL UTILITIES
DESIG.	DESCRIPTION	NUMBER	TURNED OFF, AND AFTER A NORMAL
1K1-3	FAN STARTERS	25-26-27	SHUTDOWN HAS OCCURRED.
			2. DASHED LINES INDICATE
			RECOMMENDED FIELD WIRING BY
			OTHERS. DASHED LINE ENCLOSURES
			AND/OR DASHED DEVICE OUTLINES
			INDICATE COMPONENTS PROVIDED BY
1T1	TRANSFORMER	21	THE FIELD. SOLID LINES INDICATE
			WIRING BY TRANE CO.
			3. NUMBERS ALONG THE RIGHT SIDE OF
1TB6	TERMINAL STRIP		THE SCHEMATIC DESIGNATE THE
			LOCATION OF CONTACTS BY LINE
1U1	THERMOSTAT MODULE	23	NUMBER. AN UNDERLINED NUMBER
			INDICATES A NORMALLY CLOSED
358	CONDENSATE OVERFLOW	36	CONTACT.
			4. ALL FIELD WIRING MUST BE IN
151	DISCONNECT SW	3	ACCORDANCE WITH THE NATIONAL
159	LOWLIMIT		ELECTRIC CODE (NEC), STATE AND
			LOCAL REQUIREMENTS.
2U2	ZONE SENSOR MODULE	24
	FAN SWITCH	28
481	FAN MOTOR	9	DEVICE PREFIX
2L2	DAMPER ACTUATOR	32	LOCATION GUIDE
			AREA	LOCATION
3L1	MAIN COIL VALVE	28
			1	CONTROL PANEL
3L3	HEATING COIL VALVE	30
			2	CONTROL END
			3	PIPING END
			4	FAN SECTION
			5	COIL SECTION
			6	CUSTOMER

For Reference Only:

This schematic shows typical wiring of a fan-coil. It is not intended for a basis of design or for equipment installation purposes in the field. For an as-built schematic specific to a particular unit, please see the ship-with schematic for that specific unit or contact your local Trane representative.

Four-pipe

Two-position N/C cooling control valve

Two-position N/O heating control valve

Two-position N/C fresh air damper actuator

Condensate overflow detection

Low temperature detection

Unit mounted fan mode switch,

Wall mounted setpoint dial and zone temperature sensor

Unit mounted disconnect switch

132 UNT-IOM-6