Trane LO manual Auxiliary Drain Pan, Main Drain Pan

Auxiliary Drain Pan

1. To remove the auxiliary drain pan, loosen the hose clamp (installer supplied) around the drain con-

nection collar and disconnect the drain line.

2.Remove the overflow drain line to the auxiliary drain pan if it was installed.

3.Remove the condensate over- flow switch option from the auxiliary drain pan.

4.Slide the pan horizontally towards the end of the large groove of the mounting slots in the chassis end panel and remove pan from unit. See Figure 31.

Figure 31. Insert the auxiliary drain pan tabs into these slots in the fan-coil’s chassis end panel. A horizontal unit is pictured.

Main Drain Pan

!CAUTION: Exercise extreme care when removing auxiliary drain pan. Failure to do so may cause plastic mounting tabs to break.

Note: When replacing the main drain pan, install it correctly under the z-bar as pictured in Figure 32.

Coil

➤

Main Drain Pan

➤

Side

View

Z-Bar

➤

Figure 32. When replacing the fan-coil’s main drain pan, install it correctly under the z-bar.

UNT-IOM-6 119