Wall Control Installation (continued)
! WARNING
Check to see that all connections are tight and that no bare wires are visible at the wire connectors.
6.Screw wall control into wall box using the supplied screws. Leave wall control in “OFF” mode until fan installation is completed.
7.The wall control is supplied with a white, ivory, and almond color switch covers. Choose the finish that best suits your needs and snap the cover onto the wall control (Figure 17).
8.Next, install the other wall control into the wall box containing the load wire. Connect the black wire of the wall control to the traveler wire(s) already connected to the black wire (in the other wall box). Secure with wire connectors supplied.
9.Connect one black wire of the wall control to the “load” (black) wire and secure with wire connector supplied.
10.Restore electricity to your ceiling fan from the main fuse box or breaker panel.
STANDARD WIRING FOR EXISTING 3-WAY CONTROLS
EXISTING
WALL CONTROL
HOT BLK |
|
| BLACK |
TRAVELER WIRES | LOAD |
|
3-WAY WIRING DIAGRAM: RETROFIT
BLK | BLK |
|
|
HOT BLK |
|
| BLK |
|
|
| |
EMERSON |
| EMERSON | BLACK |
FAN/LIGHT |
|
| |
|
|
| |
WALL CONTROL |
|
| LOAD |
TRAVELER WIRES |
|
Figure 19
3-WAY WIRING DIAGRAM: NEW CONSTRUCTION
HOT | SW605 |
|
| FAN/LIGHT |
|
EMERSON | WALL | EMERSON |
| CONTROL |
|
BLACK | BLK | BLK |
| ||
| TRAVELER |
|
NEUTRAL | WIRE |
|
RECEIVER LOCATED
ON TOP OF THE
CEILING FAN
Figure 18
LOAD
BLACK
GROUND
Maintenance
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.
! WARNING
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.
11 | ETL Model No.: CF550 |