Emerson CF550ORB00, CF550BS00 owner manual Using Your Ceiling Fan, Light

Programming the Receiver Operating Frequency & High Speed Conditioning of Fan Control

IMPORTANT: Ceiling fan blades MUST be installed before high speed conditioning can begin.

1.Within 1 minute of restoring electricity to the

ceiling fan, push and hold the fan OFF button () for 3 to 5 seconds to set the code in the receiver. The ceiling fan lights (if installed) will blink to indicate the transmitted has been paired with the receiver.

IMPORTANT: Immediately after successful pairing, the ceiling fan will automatically begin high speed conditioning of the motor. During conditioning, the electronic motor control software is calculating speeds for the 2nd through 5th speed settings based on the blades that were installed on the fan.

2.The fan will run for approximately 2 minutes in the upward direction then reverse direction to down flow and run an additional 2 minutes. When conditioning is complete, the fan will come to complete stop.

IMPORTANT: Do not interrupt the conditioning until the fan comes to a complete stop in approximately 5 minutes. All functions of the control will be rejected during conditioning.

3.High speed conditioning is now complete.

4.If programming is unsuccessful, retry the above instructions after cycling the wall control ON/OFF switch to restart the 1 minute programming time period.

5.If still unsuccessful, shut off the electricity at the fuse box or breaker panel and change the wall control frequency (page 9). After changing the frequency settings, repeat instruction #1 of this section within one minute of restoring the electricity.

Using Your Ceiling Fan

! WARNING

Fan installation must be completed, including the installation of the fan blades, before testing the remote control.

POWER INDICATOR LIGHT

Your wall control has full control of your fan and light.

1.To set the desired fan speed, press the ( ) button

to decrease the speed and the ( ) to increase the

speed. The LED display will light up to indicate the

FAN DIRECTION

LIGHT BUTTON

new speed selected.
2.To turn the light on and off, press and release the
LIGHT (	) button. To set the light intensity, press
and hold the LIGHT ( ) button. The light will turn
on at the light intensity previously selected.
3.Your wall control comes complete with your choice
of three wall cover plates; ivory, white and light
almond.
4. If airflow is desired in the opposite direction, press
the (	) button on the wall control. The fan must
be operating at any speed for the reverse button to
function. The blades will turn in the opposite
direction and reverse the airflow.

FAN	HIGH TO LOW
	SPEED BUTTONS
BUTTON

ON/OFF SWITCH

O = OFF / — = ON

Figure 20

12 ETL Model No.: CF550