Weed Eater 545117506, HTC2200 instruction manual User Replaceable Service Parts, Battery Disposal

USER REPLACEABLE SERVICE PARTS

REPLACEMENT PART	PART NUMBER
Battery Pack	545124416
Charger	545124415

STORAGE

WARNING: Perform the following steps after each use.

SStop the unit and remove the battery pack

when not in use.

SCarry the unit with motor stopped.

SStore the unit so the blades cannot cause

injury.

SStore unit indoors in a high, dry place out of

the reach of children.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

BATTERY DISPOSAL

WARNING: Remove the battery pack from the hedge trimmer. Cover the terminals with heavy duty adhesive tape. Do not attempt to destroy or disassemble battery pack or re- move any of its components. Nickel--cadmium batteries must be recycled or disposed of prop- erly. Also, never touch both terminals with metal objects and/or body parts to avoid short circuit- ing the battery pack. Keep away from children. Failure to comply with these warnings could re- sult in fire or serious personal injury.

STo preserve natural resources, please re- cycle or dispose of batteries properly.

SThis product contains nickel--cadmium batter- ies. Local, state or federal laws may prohibit disposal of nickel--cadmium batteries in ordi-

nary trash.

SConsult your local waste authority for infor- mation regarding available recycling and/or disposal options.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and remove battery pack before performing all of the recommended remedies below except remedies that require unit to be operating.

TROUBLE	CAUSE		REMEDY
Unit fails to	1.	Battery not attached to	1.	Remove battery and check connectors.
operate	2.	unit correctly.	2.	Replace battery.
		Battery needs charging.		Charge battery pack.
	3.	Debris stopping blade.	3.	Remove debris.
Cutting blades	1.	Forcing blade into	1.	Cut at a slower pace.
stop under a		material being cut.
load or do not	2.	Blades clogged with	2.	Clean debris from blades.
move when		debris.	3.	Charge battery pack.
trigger switch	3.	Battery needs charging.
is pressed	4.	None of the above	4.	Contact your authorized service dealer.
Poor cutting	1.	Unit is being used	1. Ensure the product is being used
quality		incorrectly.		correctly.
	2.	Blades clogged with	2. Clean debris from blades.
		debris.
	3.	Damaged blades.	3. Contact your authorized service dealer.
Excessive	1.	Damaged blades.	1. Contact your authorized service dealer.
vibration

9