Weed Eater WE14542K owner manual Check Babery See Fig, Install Seat See Fig

ASSEMBLY

HOW TO SET UP YOUR TRACTOR

CHECK BA'B'ERY (See Fig. 2)

Lift seat pan to raised position and open battery box door.

•If this battery is put into service after month and year indicated on label (label located between terminals)

•- charge battery for minimum of one hour at 640 amps. (See "BATTERY" in CUSTOMER RESPONSIBILITIES

section of this manual for charging instructions).

SEAT

LABEL

BOX

TERMIR

FIG. 2

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment bolt.

Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor•

•Pivot seat upward and remove fror_ the cardboard packing. Remove the cardboard packing and discard.

•Place seat on seat pan and assemble shoulder bolt, Tighten shoulder bolt securely,

•Assemble adjustment bolt. Iockwasher and flat washer loosely. Do not tighten.

Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal allthe way down.

•Get off seat without moving its adjusted position. Raise seat and tighten adjustment bolt securely.

SHOULDER	\	_	\_\	\ \\\
BOLT	_	\\	\_y_ _ \ \ \	\\	\

BOLT

FIG.3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Operation section, page 10, for location and function of controls)

•Press lift lever plunger and raise attachment liftlever to its highest position.

•Release parking brake by depressing clutch/brake pedal. Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

Remove banding holding discharge guard up against tractor.

7