MAINTENANCE
LAWN MOWER
Always observe safety rules when per- forming any maintenance.
IMPORTANT: Always unplug electric mow- ers before servicing, cleaning or removing material from lawn mower.
TIRES
•Keep tires free of gasoline, oil, or insect control chemicals which can harm rub- ber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
BLADE CARE
For best results, blade must be kept sharp. Replace a bent or damaged blade.
CAUTION: Use only a replacement blade approved by the manufacturer of your mower. Using a blade not approved by the manufacturer of your mower is hazardous, could damage your mower and void your warranty.
TO REMOVE BLADE
1.Use a wood block between blade and mower housing to prevent blade from turning when removing blade nut.
NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.
2.Remove blade nut by turning counter- clockwise.
3.Remove blade and attaching hardware (nut, square washer, insulator washer).
Trailing edge
Insulator washer
Blade nut
Blade
Square washer
TO REPLACE BLADE
1.Be sure the trailing edge of blade (op- posite sharp edge) is up toward the motor.
2.Install the square washer and insulated washer; secure with blade nut.
3.Use block of wood between blade and lawn mower housing and tighten the blade nut, turning clockwise.
•The recommended tightening torque is
TO SHARPEN BLADE
NOTE: We do not recommend sharpening blade. An unbalanced blade will cause eventual damage to lawn mower or motor.
CLEANING
WARNING: To reduce the risk of electric shock, do not expose the mower to water.
IMPORTANT: For best performance, keep mower housing free of grass
•Clean the underside of your lawn mower by scraping to remove buildup of grass and trash.
•Clean motor cover often to keep trash from accumulating.
•Keep fi nished surfaces and wheels free of all gasoline, oil, etc.
GRASS CATCHER
Grass catcher may be hosed with water but must be dry when used.
CAUTION: Under normal usage, the
catcher material is subject to deterioration and wear and should therefore be checked to ensure compliance with original manufacturer specifi cations.
13
