CHECK FOR DAMAGED OR WORN PARTS
Contact your authorized service dealer for replacement of damaged or worn parts.
SON/OFF Switch
SInlet Cover
AFTER EACH USE
INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension cord.
S After each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth.
SWipe off unit with a clean dry cloth.
CLEAN COLLECTION BAG IMPORTANT: THE COLLECTION BAG
MUST BE PROPERLY EMPTIED.
D You must properly empty and maintain the collection bag to avoid deterioration and obstruction of air flow.
DRemove the collection bag from the unit and empty after each use. Do not store bag without emptying the bag of all con- tents (grass, leaves, etc.).
DWash the bag once a year. Remove the bag from the blower and turn the bag in- side out. Wash the bag with a water hose. Allow the bag to hang and dry completely before you reuse the bag.
SERVICE
HOW TO REMOVE AN OBJECT FROM THE AIR INTAKE
WARNING: Stop the unit and dis- connect from the power source before opening the inlet cover. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades.
1.While holding the inlet cover open, remove the vacuum tubes. The inlet cover must be held open through all remaining steps.
2.Carefully reach into the vacuum opening and clear out the air intake area. Clear all debris from impeller.
3.Inspect the impeller for cracks. If cracked or damaged, do not use the unit. Have parts replaced by your au- thorized service dealer. Do not at- tempt to replace them yourself.
STORAGE
WARNING: Perform the following steps after each use:
SStop unit and disconnect from the power source.
S Allow motor to cool before storing or transporting.
SStore unit with all guards in place. Posi- tion unit so that any sharp object cannot accidentally cause injury.
S Store unit unplugged, well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of the season or if it will not be used for 30 days or more.
If your blower is to be stored for a period of time:
SStop unit and disconnect from the power source.
SClean the entire unit before lengthy stor- age.
S Open inlet cover and clean any dirt, grass, or debris that has collected. In- spect the blower and all tubes. Close and make sure the cover is latched.
SClean air vents and air inlet of debris.
SStore your unit and extension cord in a well ventilated area and covered, if pos- sible, to prevent dust and dirt accumula- tion. Do not cover with plastic. Plastic
cannot breathe and may cause con- densation and eventual rust or corro- sion.
S Check entire unit for loose screws. Re- place any damaged, worn, or broken parts.
9
