UNITY 4600 USER’S MANUAL
800032-01 Rev. F 32 www.wegner.com
ADDE location COMPEL-req [tags-req] [aud1] [aud1_rt] [aud2] [aud2_rt] [margin]
location:Value from 1 up to max (highest entry #) indicating location in Preset table.
COMPEL-req:Values are REQ, NR, or GL.
Forces COMPEL to be temporarily required, not required, or left as normal global unit
setting (respectively) when attempting this Preset during Recovery.
tags-req:Values are REQ, NR, or GL.
Forces Carrier ID Tags to be temporarily required, not required, or left as normal global
unit setting (respectively) when attempting this Preset during Recovery.
aud1:Language descriptor (or wildcard ‘*’) for audio stream to be assigned to Audio port 1.
aud1_rt:S - Stereo (left and right components routed as connected at original MPEG encoder)
1 - Original left component to both L and R outputs
2 - Original right component to both L and R outputs
M - Sum of left and right components to both L and R outputs
R - Reverse of "Stereo" above (if allowed by hardware)
aud2:Language descriptor (or wildcard ‘*’) for audio stream to be assigned to Audio port 2.
aud1_rt:Same as aud1_rt above
margin:Margin offset in dB. Ranges between 0 and N dB. (See MARGIN command for N.)
This command augments the ADDS command to populate the extended Preset Entry. Note that if this
Preset is used to acquire services (through Recovery or user command), these temporary COMPEL and
Tags-required parameters, if used, will be adopted as the permanent global unit parameters.
ADDS location [format] [feed #] [carrier freq] [data rate] [FEC] [Tag Site] program# [label]
location:Value from 1 up to max (highest entry #) indicating location in settings table.
For format, feed #, carrier freq, data rate, FEC, tag site, program #, and label see PERM command.
This command adds entries to the U5000-style preset table at the entry number given. If entry at location
was already in use, it will be overwritten.
APPSTAT
Forces IRD to report the status of the two application storage spaces, showing current and backup
application software (if any). A Local Control Command (available from the terminal regardless of "Local
Control Enable/Disable" commands from the network).
APPSWITCH
Unloads the currently executing application software and, instead, loads and runs the backup software.
AUDATTEN port# atten
port#:Either 1 or 2 for audio ports 1 or 2.
atten:Must be a numeric value for attenuation in dB. Legal values are given in individual IRD
specifications.
This command sets audio attenuation, where 0 gives 0dB attenuation (maximum level). A Local Control
Command (available from the terminal regardless of "Local Control Enable/Disable" commands from the
network).
Table 3.3: Command Directory for U4600 Terminal Commands