9.Press a 40mm x 50mm Inner Cap (23) into the indicated end of the Right Butterfly Arm (11). Wet the bottom end of the Arm with soapy water. Slide a Large Foam Pad (19) onto the Arm.
Attach a Pivot Bracket (48) to the Right Butterfly Arm (11) with an M10 x 50mm Bolt (62) and an M10 Nylon Locknut (71). Do not overtighten the
Locknut; the Pivot Bracket must be able to pivot easily.
Slide a Foam Grip (76) onto the Right Handle (13). Attach the Handle to the Right Butterfly Arm (11) with two M8 x 15mm Bolts (64).
Slide the Large Foam Pad (19) down so that the bottom of the Foam Pad is even with the bottom of the Arm.
Repeat this step with the Left Butterfly Arm (10).
10.Lubricate an M10 x 82mm Bolt (50) and both sides of two Plastic Washers (55) with grease. Attach the Right Butterfly Arm (11) to the Butterfly Frame (9) with the Bolt, the two Plastic Washers, two Butterfly Caps (54), and an M10 Nylon Locknut (71). Do not overtighten the Locknut; the Butterfly Arm must be able to pivot easily. Be sure the indented sides of the Plastic Washers fit over the welded bushing in the Butterfly Arm.
Repeat this step with the Left Butterfly Arm (10).
11.Press two 40mm x 50mm Inner Caps (23) into the ends of the Leg Lever (4).
Lubricate an M10 x 65mm Bolt (59) with grease. Attach the Leg Lever (4) to the Seat Upright (73) with the Bolt and an M10 Nylon Locknut (71). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.
9 | 62 |
|
| |
11 |
|
| ||
|
| 48 |
| |
|
|
|
| |
| 71 |
| 23 |
|
|
|
|
| |
64 | 64 |
|
| 10 |
|
|
| ||
19 |
|
|
|
|
| 76 |
|
|
|
| 13 |
|
|
|
10 |
|
|
|
|
Welded | Lubricate |
| ||
|
| 50 | ||
Bushing |
| 55 | ||
|
|
|
| |
11 |
|
| 54 |
|
|
|
|
| |
| 55 |
| 9 |
|
|
|
|
| |
| Lubricate | 54 | 10 | |
|
|
|
| |
|
|
| 71 |
|
11 |
|
|
|
|
| 23 |
| 73 |
|
|
|
|
| |
71 |
|
| 59 |
|
4 | Lubricate |
| ||
23 |
|
|
|
|
8
