2.Attach a Wheel (31) to the outside of the Base (1) with an M10 x 78mm Bolt (81), three M10 Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel must be able to turn easily.
Attach the other Wheel (not shown) in the same manner.
3.Orient the Cross Tube (11) as shown, with the welded tubes at the bottom. Attach the Cross Tube and the Foot Plate (23) to the Upright (3) with two M10 x 140mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nuts (47). Do not insert a bolt into the upper hole in the Foot Plate yet.
4.Press the Front Leg Foot (27) onto the bottom of the Front Leg (6). Note that the front of the
Front Leg Foot is taller than the back.
Attach the Bench Rail (5), with the hook on the bottom, to the Front Leg (6) with two M10 x 53mm Carriage Bolts (61) and two M10 Nylon Locknuts (76).
5.Lubricate the M10 x 103mm Bolt (66) with grease. Attach the Bench Rail (5) to the Upright
(3) with the Bolt and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Bench Rail must be able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3) and the Bench Rail (5).
2 |
|
|
|
| 76 | 75 |
|
|
|
| 75 |
|
|
| 81 |
|
| 31 |
|
| 1 |
|
|
3 |
|
|
|
23 | 3 | 75 | 47 |
|
|
| |
73 |
| 11 |
|
|
|
| |
|
|
| Welded |
|
|
| Tube |
4 |
|
|
|
|
| 5 |
|
| 76 |
| Hook |
|
|
| |
61 | 76 |
|
|
|
|
| |
Front | 6 |
|
|
|
|
| |
| 27 |
|
|
5 |
|
| 3 |
|
| 30 | |
|
|
| |
| Insert the bolt | 76 |
|
| through this hole |
|
|
| 5 |
| 66 |
|
|
| |
|
| Lubricate | |
6
