14.Lift the High Cable (26) in the location shown. Attach two Pulleys (25) inside the Weight Guide Frame (14) using two M10 x 75mm Bolts (36), four M10 Flat Washers (41), four 18mm Spacers (45), and two M10 Nylon Locknuts (31).
15.Pull the High Cable (26) down in the indicated loca- tion, so there is no slack at the ends of the High Cable.
Locate the Low Cable (27), which is shorter and has two balls on one end. Insert the
Route the
(25)inside the bracket using an M10 x 45mm Bolt
(34)and an M10 Nylon Locknut (31).
16.Hold a Pulley (25) in the High Cable (26) as shown. Attach a Cable Trap (24) and the two Pulley Plates (17) to the Pulley using an M10 x 45mm Bolt (34) and an M10 Nylon Locknut (31).
Lay the Low Cable (27) over a Pulley (25) as shown. Attach the Pulley and a Cable Trap (24) to the Pulley Plates (17) using an M10 x 45mm Bolt
(34)and an M10 Nylon Locknut (31). Make sure the Bolts are inserted through the highest and lowest holes in the Pulley Plates. In addition, make sure the Cables are between the Cable Traps and the Pulleys.
14 |
| 25 |
|
| |
41 |
| 26 |
45 | 14 | |
31 |
| |
41 |
| 45 |
| 41 | |
45 |
| 36 |
|
| |
|
| 45 |
|
| 41 |
15 |
|
|
| 26 |
|
|
| 27 |
|
| 25 |
|
| 41 44 |
|
| 4 |
2 | 31 | 44 |
41 |
36 34
1626
17
25
3124
17
34
24
27
10