Weider WEBE03820 user manual Removing and Attaching the FLY Arms, Attaching the LAT Tower

REMOVING AND ATTACHING THE FLY ARMS

Some exercises are easier to perform if the Fly Arms

(25)are removed from the weight bench. To remove the Fly Arms, remove the Butterfly Knob (13) and the M10 x 115mm Bolt (19) from each Fly Arm and Upright (1). Place the Fly Arms in a safe place.

To re-attach the Fly Arms (25), align the holes in the Fly Arms with the holes in the Uprights (1). Insert the M10 x 115mm Bolts (19) through the Fly Arms and Uprights. Tighten the Butterfly Knobs (13) onto the Bolts.

ATTACHING THE LAT TOWER

For some exercises, the Lat Tower (40) must be attached to the weight bench. To do this, remove the 38mm Square Inner Cap (21) from the Front Leg (8). Insert the Lat Tower into the Front Leg and align the indicated hole in the Lat Tower with the adjustment hole in the Front Leg. Secure the Lat Tower with the Adjustment Knob (31).

Note: When the Lat Tower (40) is not being used, it should be stored away from the weight bench, and the 38mm Square Inner Cap (21) should be inserted into the Front Leg (8).

WARNING: When you are using the Lat Tower (40), place a barbell (not included) with the same amount of weight on the weight rests to balance the bench.

	13
25	1
19
40
21
Hole
	Adjustment
	Hole
	31
8

11