2650 PSI Pressure Washer
How to Use Spray Tips
The
Follow these instructions to change spray tips:
1.Engage safety latch on spray gun.
CAUTION
A pressure washer produces a high pressure spray which increases risk of injury and damage to unit.
•NEVER exchange spray tips without engaging the safety latch on the spray gun trigger.
2.Pull back collar on
3.Select desired spray tip:
•For gentle rinse, select white 40° spray tip.
•To scour surface, select yellow 15° or red 0° spray tip.
•To apply chemical, select black spray tip.
Figure 12 — Spray Tip Spray Patterns
Low Pressure
Black
Use to apply
chemical
High Pressure
40° White |
| 15° Yellow |
| 0° Red |
4.Pull back on collar, insert new spray tip and release collar.Tug on spray tip to make sure it is securely in place.
5.For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray tip too close, you may damage cleaning surface.
6.DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage the pump.
CAUTION
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
To apply detergent follow these steps:
1.Review spray tip use.
2.Prepare detergent solution as required by manufacturer.
3.Place small filter end of detergent siphoning tube into detergent container.
CAUTION
Keep the chemical injection tube from coming in contact with the hot muffler.
•When inserting filter into a detergent solution bottle, route tube to keep it from inadvertently contacting hot muffler.
4.Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high pressure spray tips (White,Yellow, or Red).
5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump and start engine.
6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
12
