INSTALLATION
Continued
ASSEMBLING AND ATTACHING OPTIONAL PERIMETER TRIM (Included with Mantel Accessory)
Note: The instructions below show assembling and attaching trim to fireplace.
1.Remove packaging from three pieces of trim.
2.Locate four screws, two adjusting plates with set screws, and two shims in the hard- ware packet.
3.Align shim under adjusting plate as shown in Figure 28.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 28).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 28).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other side.
8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 29). Push trim firmly into place, sliding hanging notches over hanging screws.
|
| Set | |
| Adjusting | Screws | |
| Top Trim | ||
Side Trim | Plate | ||
| |||
|
|
Shim Slot
Slot
Mitered Edge
Figure 28 - Assembling Perimeter Trim
Trim Hanging Screws
Assembled
Trim
Hanging Notches on Trim
Figure 29 - Attaching Perimeter Trim to Fireplace
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 30. Use 3 Phillips screws provided.
Figure 30 - Installing Hood to Firebox
www.desatech.com | 19 |