2.Press a 2Ó Square Inner Cap (17) into the top end of one Upright (1).
Press a 2Ó Square Inner Cap (17) into each end of the Left Stabilizer (25).
Press a 38mm x 38mm Square Inner Cap (31) into the top of the tube on the Left Stabilizer (25).
Insert three M10 x 62mm Carriage Bolts (33) through the holes in the Left Stabilizer (25). Note: On one side of the Stabilizer there is an indentation around the holes. Insert the Bolts from this side.
Place the Stabilizer flat on the floor.
Place the Upright (1) over the three M10 x 62mm Carriage Bolts (33) in the Left Stabilizer (25). Secure the Upright with three M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
3.Note: The Left Stabilizer (25) has a tube that allows you to store the Curl Pad and Lat Tower (44 and 9, not shown). Depending on where you plan to place the weight bench, it may be more practical for you to have this storage tube on the right side of the bench. If so, simply switch the two Uprights (1) before attaching the Crossbar (20).
Insert two M10 x 68mm Bolts (34) through the holes in one of the Support Plates (16) and then through the indicated holes in one Upright (1).
While a second person is holding the Upright (1), slide the bracket on the Crossbar (20) over the two M10 x 68mm Bolts (34). Secure the Crossbar with two M10 Nylon Locknuts (11).
Attach the Crossbar (20) to the second Upright (1) in the same manner.
2 |
| 17 |
|
|
| 1 |
|
| 11 |
| 31 |
|
|
| |
| 11 |
|
|
|
|
| 17 |
|
|
| 25 |
| 17 | 33 |
|
|
|
| |
| 33 |
|
|
3 |
|
|
|
| 1 |
|
|
|
|
| 1 |
34 |
|
|
|
| 11 |
|
|
16 | 20 | 11 | 25 |
| |||
|
| ||
|
|
| |
| 11 |
|
|
| 11 |
|
|
|
|
| 16 |
|
|
| 34 |
7