14.Press two Weight Rest Bushings (23) into a Weight Rest (47) as shown. Pull the Weight Rest Knob (31) and slide the Weight Rest onto one of the Front Uprights (1). Hold the Weight Rest at the desired height and tighten the Weight Rest Knob into one of the adjustment holes in the Front Upright.
Attach the other Weight Rest (47) to the other Front Upright (1) in the same way. Make sure that both
Weight Rests are at the same height.
15.Press a 60mm Square Inner Cap (9) into one of the Front Uprights (1). Attach two Upper Support Plates (56) to the Front Upright with two M10 x 78mm Bolts (33) and two M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
Repeat this step with the other Front Upright (1, not shown).
16.Attach a Rear Upright (25) to the Left Base (2) and the indicated Upper Support Plates (56) with four M10 x 78mm Bolts (33) and four M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
Attach the other Rear Upright (25) to the Right Base (7, not shown) and the other Upper Support Plates (56) in the same manner.
Tighten all nylon locknuts used in steps 11 through 16.
14 |
| |
23 |
| |
| 31 | |
23 | 47 | |
| ||
1 | Adjustment | |
Holes | ||
15 | 9 | |
56 | ||
| ||
11 | 56 | |
| ||
1 | 33 | |
| ||
16 | 56 | |
11 | ||
| 33 | |
| 25 | |
| 11 | |
2 |
| |
| 33 |
10
