Weider WESY19510 user manual

15. Route the Long Cable (23) around the “V”-Pulley	15			50	7
(6) on the Right Arm (48). Be sure that the
Cable is in the groove of the “V”-Pulley and					6
that the Long Cable Trap (50) is turned to hold
the Cable in place. Tighten the 3/8” x 2 1/2” Bolt
(7) and the 3/8” Nylon Locknut (not shown).
					48
			23
16. Route the Long Cable (23) around the 3 1/2”	16		68	66
Pulley (15) attached to the Pulley Bracket (20).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap (66) is turned
to hold the Cable in place. Tighten the 3/8” x 2”		20
Bolt (12) and the 3/8” Nylon Locknut (not shown).
Be sure that the 5/16” x 5” Bolt (68) is properly		12
tightened and that the Pulley Bracket (20) can		23		15
move freely.
17. See the inset drawing. Attach a 3 1/2” Pulley (15)	17
and a Cable Trap (66) to the indicated hole in the
Long “U”-Bracket (57) with a 3/8” x 2” Bolt (12)
and a 3/8” Nylon Locknut (21). Be sure that the
Cable Trap is inside the “U”-Bracket. Note:
This may come pre-assembled.
Route the Long Cable (23) between the 3 1/2”		23			23
Pulley (15) and the Cable Trap (66). Be sure that		66	15
the Cable is in the groove of the Pulley and			12
that the Cable and Pulley move smoothly.
		21
		57
18. Note: The 3 1/2”Pulley (15) in this drawing is	18				15
pre-assembled. It is shown disassembled for				23
easy part identification.			Bracket		12
Route the Long Cable (23) around the 3 1/2”
Pulley (15) attached to the bracket on the Top			55
Frame (55). Tighten the 3/8” x 2” Bolt (12) and
the 3/8” Nylon Locknut (21). Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.			21
	10