22.Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the upper hole in the Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (71).
23.Attach the end of the Short Cable (58) to the Long
(2) and a 1/4” Flat Washer (10). See the inset drawing. Do not overtighten the Nylon Locknut; it should be threaded onto the end of the Cable so only a couple of threads are showing above the nut.
22 | 42 |
| 15 |
| 71 |
| 66 |
| 58 |
| Inset shows view |
| from other side |
| 58 |
42 | 15 |
21 |
|
23 |
|
| 2 |
| 57 |
| 10 |
| 58 |
| 2 |
| 10 |
57 | 58 |
12
