Weider WESY19510 user manual Arm. Arm identification is very important for Step

8.	Press a 1 3/4” Square Inner Cap (44) into the top	8				44
	of a Press Arm (46). Press a 1” Round Inner Cap
	(49) into each end of the handle on the Press
	Arm.					49
	Attach the Press Arm (46) to one side of the		44		49
	Press Frame (17) with two 5/16” x 2 1/2” Bolts
						46
	(22) and two 5/16” Nylon Locknuts (3).		49
	Assemble the other Press Arm (46) in the same		46		22
	manner.
						3
						17
9.	Identify the Right Arm (48) and the Left Arm (47).	9			7	50
	Note the position of the welded bracket on each			50
						6
	Arm. Arm identification is very important for			6
	step 10.
	Note: The “V”-Pulleys (6), Long Cable Traps (50),		Welded			47
			Brackets
	3/8” x 2 1/2” Bolts (7), and 3/8” Nylon Locknuts					21
	(21) are pre-attached. These have been shown
	disassembled for easy part identification.
			48
10.	Lubricate both axles on the Top Frame (55).	10			55
						47
	Slide the Right Arm (48) onto the right axle on the
	Top Frame (55). Note: Be careful not to con-
	fuse the Right Arm with the Left Arm (47);
	refer to step 9 to identify the Right Arm. Be					Bracket
	sure that the upper end of the Right Arm is					Lubricate
	behind the indicated bracket on the Top
	Frame.
	Tap two 1” Retainers (69) and a 1” Round Cover		48			69
						70
	Cap (70) onto the right axle. Be sure that the
	teeth on the Retainers bend toward the Cover					45
	Cap, as shown in the inset drawing.
	Attach the Left Arm (47) in the same manner.
	Press a 1 3/4” Square Inner Cap (44) into the
	lower ends of the Right and Left Arms (47, 48).
	Wet the end of each Arm with soapy water, and		44
	slide a 10” Pad (45) onto the Arm.
			45			55
						69
						70
		8