48.Wrap the Squat Cable (73) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated bracket on the Long Base (120) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

49.Wrap the Squat Cable (73) over a 4 1/2” Pulley (119). Attach the Pulley to the indicated bracket on the Top Frame (6) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

50.Place a 1/2” Washer (1) on top of the Weight Tube

(43)closest to the Squat Upright (4). Tighten a 1/2” Nut (118) halfway onto the end of the Squat Cable

Lift the Weight Tube (43) and the Top Weight (45) and make sure that the small pin on the Weight Tube is inside of the groove under the Top Weight.

Hold the Weight Tube (43) and the Top Weight (45) a few inches over the weight stack while you screw the end of the Cable (73) two full turns into the Weight Tube. Then, tighten the Nut against the 1/2” Washer (1).

SEAT ASSEMBLY

51.Locate and open the parts bag labeled “SEAT ASSEMBLY.”

Insert the Pad Tube (23) into the square hole in the Seat Upright (9). Slide the two Knee Pads (19) onto the Pad Tube as shown. Press the two Knee Pad Caps (109) into the ends of the Pad Tube.

Slide two Short Pads (20) onto the Leg Lever (10).

19

48

 

 

 

 

 

 

78

 

73

 

87

 

 

 

 

93

120

 

 

 

 

49

 

6

87

 

 

 

93

 

 

 

 

 

119

 

 

 

73

50

 

 

 

 

 

 

4

 

 

73

 

 

 

118

 

 

 

1

45

 

 

 

 

 

43

 

51

19

 

 

 

 

 

109

23

 

 

 

 

 

 

 

9

19

 

20

 

109

 

10

 

 

 

 

20

Page 19
Image 19
Weider WESY38321 user manual Locate and open the parts bag labeled Seat Assembly