2.Attach a Wheel (31) to the outside of the Base (1) with an M10 x 108mm Bolt (81), three M10 Washers (75), and an M10 Nylon Locknut (76).
Do not overtighten the Locknut; the Wheel must be able to turn easily.
Attach the other Wheel (not shown) in the same manner.
3.Press a 38mm x 64mm Inner Cap (41) into each end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the welded tubes at the bottom. Attach the Cross Tube to the Upright (3) with two M10 x 140mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nuts (47).
4.Press a 38mm x 76mm Inner Cap (34) into the end of the Bench Rail (5).
Press the 38mm x 76mm Dome Cap (87) into the top of the Front Leg (6). Press the Front Leg Foot (27) onto the bottom of the Front Leg. Note that the front of the Front Leg Foot is taller than the back.
Attach the Bench Rail (5) to the Front Leg (6) with two M10 x 53mm Carriage Bolts (61) and two
M10 Nylon Locknuts (76). Make sure the parts are oriented as shown in the inset drawing.
5.Lubricate an M10 x 103mm Bolt (66) with grease. Attach the Bench Rail (5) to the Upright (3) with the Bolt and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Bench Rail must be able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3) and the Bench Rail (5).
2 |
|
|
|
| 76 | 75 |
|
|
|
| |
|
|
| 75 |
|
|
| 81 |
|
| 31 |
|
| 1 |
|
|
3 | 41 |
|
|
|
|
| |
| 3 | 75 | 47 |
|
|
| Welded |
|
|
| Tube |
|
| 11 |
|
| 73 |
| 41 |
4 |
| Hole | |
|
| ||
|
| 5 | 34 |
| 76 |
|
|
| 87 |
|
|
| 76 |
|
|
| 61 |
|
|
| 6 |
| 5 |
| Front |
| |
|
| 6 | |
| 27 |
| |
|
|
| |
|
|
| 27 |
5 |
| 30 | 3 |
|
| ||
| Insert the bolt | 76 |
|
| through this hole |
|
|
| 5 |
| 66 |
|
|
| |
|
| Lubricate | |
6
