Weider WESY5773.0 user manual

12.Press two 25mm Square Inner Caps (54) into the indicated end of the Backrest Frame (15).

Attach a Plastic Foot (53) to the Backrest Frame (15) with an M4 x 16mm Screw (62).

Attach the two Guard Plates (17) to the inside of the Backrest Frame (15) with four M4 x 16mm Screws (62).

13.Orient the Backrest (14) and the Backrest Backing (8) as shown. Attach the Backrest and the Backrest Backing to the Backrest Frame (15) with four 1/4” x 45mm Button Screws (58).

Insert the rod on the Backrest Frame (15) into the slot in the Seat Carriage (12). Hold the Backrest

Frame vertically over the Seat Carriage and slide the rod into the slot, as shown in the inset drawing.

14.Attach the two 10-pound Short Caps (20) to the 10-pound Center Resistance Bar (44) with two M4 x 12mm Flat Head Screws (85).

Using twelve M4 x 12mm Flat Head Screws (85), attach the two 10-pound Caps (101) to the 10- pound Removable Resistance Bar (67), the two

20-pound Caps (88) to the 20-pound Removable Resistance Bar (36), the six 80-pound Caps (100) to the two 80-pound Resistance Bars (95) and the 80-pound Top Resistance Bar (105), and the two 40-pound Caps (79) to the 40-pound Resistance Bar (96).

15.Orient the Cover Plate (72), with the edges up. Attach the 80-pound Top Resistance Bar (105) to the Cover Plate with the two 1/4” x 25mm Screws (108). Note: The Top Resistance Bar is closer to the back of the Cover Plate.

12			15
				53
				62
	54		62
		17
		62
		17
13
14
8				15
				Rod
15					Slot
		58			12
14				105
				96	100
				95
			36	85	79
		67
		44		85	100
				85
			85	88
		85	20	101
15
			105
		Edges
		up
			72	Back
			108

9