19.Attach a Bumper (40) to the Press Front Leg (20) with a 1” Tap Screw (80).
Press a 2” x 3” Inner Cap (78) into the top of the Press Leg Lever (90).
Lubricate a 1/2” x 4” Bolt (68). Attach the Press Leg Lever (90) to the Press Base (6) with the Bolt and a 1/2” Nylon Jamnut (36). Note: Do not over tighten the Nylon Jamnut; the Press Leg Lever must be able to pivot easily.
20.Insert two 2” Square Inner Caps (28) into the Leg Lever (41).
Attach a Bumper (40) to the Butterfly Front Leg (3) with a 1” Tap Screw (80).
Lubricate a 3/8” x 3” Bolt (88). Attach the Leg Lever (41) to the Butterfly Front Leg (3) with the Bolt and a 3/8” Nylon Jamnut (63). Note: Do not over tight- en the Nylon Jamnut; the Leg Lever must pivot easily.
CABLE ASSEMBLY
21.IMPORTANT: While assembling the cables, do not over tighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely. Refer to the Cable ID Chart on page 26 for help identifying the cables.
Locate and open the parts bags labeled “CABLE ASSEMBLY” and “PULLEYS.”
Secure a 3/8” x 2 1/4” Bolt (79) to the Right Pivot Arm (85) with a 3/8” Nylon Jamnut (63).
Locate the Butterfly Cable (73), which is the shorter cable of the two that have loops on both ends. Attach the Butterfly Cable to the 3/8” x 2 1/4” Bolt (79) with a 3/8” Nylon Jamnut (63). Note: Do not fully tighten the Nylon Jamnut; the Butterfly Cable must be able to pivot easily.
22.Wrap the Butterfly Cable (73) over a
(27).Attach the
(32)to the bracket on the Butterfly Upright (1) with a 3/8” x 2 1/2” Bolt (87) and a 3/8” Nylon Locknut
11
19 |
|
|
|
| 78 |
|
|
| 90 |
|
|
| 40 |
|
|
|
| 20 |
|
68 | 80 |
|
|
Lubricate | 36 | 6 |
|
|
|
| |
20 | Lubricate |
| 88 |
|
| ||
|
|
| 28 |
| 63 |
| 41 |
|
|
| |
| 40 |
|
|
|
| 80 | 28 |
|
|
| |
| 3 |
|
|
21 |
|
|
|
| 63 |
|
|
| 63 |
|
|
73 |
| 85 |
|
| 79 |
| |
|
|
| |
22 |
|
|
|
|
| 50 |
|
87 | 32 |
|
|
|
|
| |
| 27 |
|
|
| 73 | 1 |
|
|
|
|
