Weider WESY5993.2 user manual Make sure the flat edge of the Pulley Guard is On the bottom

19. Wrap the Long Cable (80) under a 90mm Pulley		19
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with a 3/8” x 4 1/2”
Button Bolt (40) and a 3/8” Nylon Locknut (76).				3
Make sure the flat edge of the Pulley Guard is									28
on the bottom.			40							76
									29
								Flat		80
								Edge
20. Attach a Pulley Housing (94) to the indicated “U”-		20
channel on the 10-pound Center Resistance Bar
(44) with a 3/8” x 4” Button Bolt (24), two Pivot				44
Bushings (74), and a 3/8” Nylon Locknut (76).								74
Wrap the Long Cable (80) around a 90mm Pulley				74					76
(28). Attach the Pulley inside of the Pulley				94
Housing (94) with a 3/8” x 1 1/2” Button Bolt (71)			24					76
and a 3/8 Nylon Locknut (76).				71
							28
21. Wrap the Long Cable (80) around a 90mm Pulley							80
		21
(28). Attach the Pulley and a Pulley Guard (29) to			28
the indicated 3/8” x 5 1/2” Carriage Bolt (73) with							29
a 3/8” Nylon Locknut (76). Make sure the flat
edge of the Pulley Guard is on the side			80					76
shown.				Flat
22. Make sure there are no Resistance Bars (not				Edge		73
shown) under the “U”-channels on the 10-pound
Center Resistance Bar (not shown). Have a sec-
ond person pull on the Long Cable (80) to create		22
slack in the Cable.
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross							71
Tube (11) and then through the remaining Swivel				Rod	22			107
Arm (22). Make sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.			80
Insert the Swivel Arm (22) into the welded tube				28			11
on the Cross Tube (11). Secure the Swivel Arm					76
with a #8 x 3/8” Screw (107).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with a 3/8” x 1 1/2”	Button Bolt (71) and a
3/8” Nylon Locknut (76).		11