Technical Services Bulletin No: SB0002 (Page 2 of 2)
Subject: GOLD Oil Boiler Primary Burner Controls #60200-02
Date: February 2, 2000
7.10-second flame stabilization period (flame established / spark remains on). If flame is established and extinguished, the control detects a flame failure and will shut off the fuel supply within 1.3 seconds. The control then enters a 65-second recycle period. After 65 seconds, the control returns to the call for heat and begins another diagnostic self-check.
8.Ignitor shuts off (spark off) – burner is now in normal cycle.
9.Call for heat is satisfied. Solenoid valve is deenergized extinguishing flame.
10.10-second motor-off-delay (postpurge).
11.Burner off.
Primary Control LED Status Indicators:
♦Amber Light “On Steady”: Control is conducting a 4-second diagnostic self-check of internal circuitry.
♦Amber Light “Flashing”: Control has detected a failure in the diagnostic self-check.
♦Red Light “On Steady”: Control is in lock-out. Reset button must be depressed for 1 second to remove from lock-out condition.
♦Red Light “Flashing”: Control is in recycle. Control has detected a loss of flame during the run cycle. Burner is off and control is performing a 65-second recycle after which the burner begins sequence of operation over and will try again for ignition.
♦Red and Amber Lights “On Steady”: Control is in latch-up. The control has experienced 3 consecutive lock-outs in one call for heat. To remove from latch-up, depress the reset button for 30 continuous seconds. After 10 seconds of depressing the reset button, the red and amber lights will begin to flash alternately for the remaining 20 seconds. After depressing the reset button for the full 30 seconds, the red and amber lights will go out. Remove your finger from the reset button and the control will return to “call for heat” position.
Carlin CCT4100 14,000-Volt Solid State Ignitor Standard Features / Benefits:
♦14,000 Volts – provides stronger / hotter spark.
♦Energy Efficient – uses only 40 VA versus approximately 240 VA standard.
♦Constant Secondary Voltage – does not fluctuate with changes in primary voltage supply.
♦Does Not Weaken Over Time – either works or it doesn’t.
♦Lighter – weighs several pounds less than a standard transformer.
♦Standard Off the shelf Part – no more special OEM transformer specifications. It is backward compatible.
♦Warranty – 3 years.
For additional information on the operation of the controls including possible causes of lock-out and latch-up, refer to the instruction manual supplied with each burner.
Attachments: WGO, WTGO, SGO & SGO-W Wiring Addendum #550-141-851/0599
