Wells F-886 operation manual INSTALLATION continued, WARNING Electric Shock hazard, Risk of Damage

INSTALLATION (continued)

WARNING: Electric Shock hazard

All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician.

DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock.

F-886 FRYER ELECTRICAL INSTALLATION

F-886 fryers must be connected directly to an appropriately sized electrical circuit. Conduit and strain relief must be provided by the electrician.

F-886 fryers are not rated for single phase operation at 208VAC.

Single phase F-886 fryers require a 240VAC 60 amp 1ø circuit with ground;

Three phase F-886 fryers require a 208VAC or 240VAC 3ø, 40 amp circuit with ground,

FRYERS ARE SHIPPED FROM THE FACTORY WIRED FOR 3ø. Conversion to single phase is the responsibility of the electrician.

CAUTION:

Risk of

Damage

DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance will result if these instructions are not followed.

CAUTION:

Electrical Shock

Hazard

The ground lug of F-886 fryers must be connected to a suitable building electric ground.

IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.

5