TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 11). Use only a | ||
sor that meets all of the specifications described on page 11. IMPORTANT: The treadmill is not | ||
compatible with |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the reset/off circuit breaker located on the | c |
|
treadmill frame near the power cord. If the switch |
| |
protrudes as shown, the circuit breaker has | Tripped | Reset |
tripped. To reset the circuit breaker, wait for five | ||
minutes and then press the switch back in. |
|
|
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | |||
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off | |||
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE | |||
INFORMATION MODE on page 16 to turn off the demo mode. |
|
| |
PROBLEM: The displays of the console do not function properly |
|
|
|
SOLUTION: a. Remove the key from the console and UNPLUG | a |
|
|
THE POWER CORD. Remove the three M4.2 x |
| 13 | |
19mm Washer Head Screws (13) and carefully |
| 53 | |
pivot the Motor Hood (53) off. |
|
| |
18
