6.While another person holds the Upright (13) in the position shown, connect the console wire to the Reed Switch Wire (43). Next, connect the Resistance Cable
(19)to the Lower Cable (45) in the following way:
•See drawing A. Pull up on the metal bracket on the Lower Cable (45), and insert the tip of the Resistance
Cable (19) into the wire clip inside the metal bracket as shown.
•See drawing B. Firmly pull up the ResistanceCable
(19) and slide it into the top of the metal bracket as shown.
•See drawing C. Using pliers, squeeze the prongson the upper end of the metal bracket together.
Push the excess Cable (19, 45) and the excess console wire down into the Frame (1), and insert the Upright into
the Frame. Be careful to avoid pinching the Wires and Cables. Attach the Uprightto the Frame with three M8 x 15mm Button Screws (34) and three M8
Split Washers (42).
7.Attach the Seat (12) to the Seat Post (5) with four M8 Split Washers (42) and four M8 Nylon Locknuts(10).
Note: The Split Washers and Nylon Locknutsmay be preattachedto the underside of the Seat.
Be careful to
avoid pinching the wires and
cables while
inserting the
Upright.
19/ I!i
,,,=_t; /43
1iI/
r
:34 t,1
AC
_._ Metal
Metal1
Bracket
7
6
