Weslo 831.291030 Maintenance and Troubleshooting, Symptom the Console does not Function Properly

MAINTENANCE AND TROUBLESHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call toll-free 1-800-4-MY-HOME®(1-800-469-4663).

1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY

a.Replace the batteries in the console (see assem- bly step 6 on page 5).

b.Make sure that the reed switch is properly adjust- ed (see assembly step 4 on page 4).

c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 7 on page 5).

d.The console, like most electronics, is susceptible to static electricity build-up caused by certain types of clothing or by the operation of the tread- mill. If the display is blank or gives incorrect read- ings, apply an anti-static spray to the handrail. Anti-static spray is available where laundry sup- plies are sold.

2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY

a. If the walk-
ing belt is	Walking Belt
overtight-
ened, per-
formance
may be
reduced and
the walking
belt may be	2"–3"
permanently
damaged.	Bolts
Using the
allen
wrench, turn both rear roller adjustment bolts

counterclockwise 1/4 of a turn. When the tension of the walking belt is correct, you should be able to lift each side of the walking belt 2 to 3 inches. Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centered.

3.SYMPTOM: THE WALKING BELT SLIPS OR IS OFF-CENTER

a. If the walking belt slips when walked on, use the

allen wrench to turn both adjustment

bolts clockwise,

1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 2 to 3 inches. Walk on the tread- mill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centered.

b. If the walking belt has shift- ed to the left side, use the

allen wrench to turn the left adjustment bolt

clockwise, and

the right adjustment bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.

c. If the walking belt has shift- ed to the right side, use the

allen wrench to turn the left adjustment bolt

counterclock-

wise, and the right adjustment bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.

8