Weslo 900 user manual Tighten the Pulse Bar Screws

6.Set the console assembly onto the Left and Right Handrails (13, 40). Be careful not to pinch the Wire Harness (65). Tighten two Pulse Bar Screws (37), with two #10 Star Washers (108), through the brackets on the Handrails and into the Pulse Bar (39). Do not tighten the Pulse Bar Screws yet.

7.Insert the Wire Harness (65) through the indicated nylon tie on the Console Base (67). Next, touch the Right Handrail (40) to discharge any static. See drawing 7a. Insert the connector on the end of the Wire Harness into the red socket beneath the Console (69). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn it and then insert it. IF THE CONNECTOR IS NOT IN-

SERTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON.

Identify the 3/4” Screws (38). Attach the Console Base

(67)to the Right Handrail (40) and the Left Handrail (not shown) with six 3/4” Screws (only three Screws are shown). Start all six Screws before tightening them; do not overtighten the Screws.

Tighten the Pulse Bar Screws (37).

8.Press the Wire Harness (65) into the indicated track in the Console Base (67). (Note: If there is a cylinder on the Wire Harness that will not fit into the track, press as much of the Wire Harness as possible into the track.) Next, insert the excess Wire Harness into the large hole in the side of the Right Handrail (40). Securely tighten the nylon tie to prevent the Wire Harness from slip- ping, and then cut off the end of the nylon tie.

Attach the Access Door (84) to the Console Base (67) with the 3/4” Screw (38).

See step 4. Tighten, but do not overtighten, the 1” Bolts (43) and the 4” Handrail Bolts (78).

6

Console Assembly

40			13
	65
	108		108
		39	37
	37
7
			65
	40
			67
	37		Tie
38
	7a		69
			65
8	67
	40
	65	84
			38
	Tie
	Track

8