Weslo E 20 Wire or the Resistance Cable, Be careful not, To pinch, Reed Switch, Back Console

1.Carefully slide the Upright (3) onto the Frame (1), while pulling the excess Reed Switch Wire (42) and Resistance Cable (31) up through the Upright. Attach the Upright with three M10 x 25mm Button Head Screws (53) and three M10 Split Washers (54). Be careful not to pinch the Reed Switch

Wire or the Resistance Cable.

2.Attach the Handlebar (37) to the Upright (3) with two M10 Split Washers (54) and two M10 x 25mm Button Head Screws (53).

3.Loosen the Frame Knob (29) on the right side of the Frame (1). Slide out the Seat Frame (2) until it stops. Tighten the Frame Knob.

4.The Console (33) requires two “AA” batteries (not included); alkaline batteries are recommended. Open the battery door on the back of the Console. Press two batteries into the Console. Make sure that the negative (–) ends of the batteries are touching the springs. Close the battery door.

1	42	31
	3
54	53
		Be careful not
	54
53	53	to pinch the
		Reed Switch
	1
		Wire or the
		Resistance
		Cable.
2
		Hole
	3
		37
		54
		54
		53
3
		29
	1
	2
4
		33
		Battery Door
		Batteries
Back of
Console

6