![](/images/new-backgrounds/1094311/9431127x1.webp)
SPA JET UNIT OPERATION
The spa jet unit features five
The five
| B |
| A |
D | C |
The whirlpool diverter (B), located on the left side of the spa jet unit, directs the flow of the water to create a whirlpool action in the DAYBREAK.
The suction vent (C), located on the right side of the spa jet unit, pulls the water into the spa unit, in order to operate the system. The suction cover should always be in place over the suction vent. Never operate the DAY-
BREAK without the C suction cover in
place.
The filter (D), is locat- | 57 | |
ed on the left side of | ||
| ||
the spa jet unit, |
| |
behind the Filter |
| |
Cover (47). The filter | 47 | |
can be removed for | ||
| ||
cleaning and replace- | D | |
ment by removing the |
| |
Filter Cover and the |
|
two Filter Cover Screws (57) and then pulling the filter from the spa jet unit.
The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been operated for three hours, the pump will begin circulat-
ing the water for twenty minutes to filter any impuri- ties. Also, if the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing.
DRAINING THE DAYBREAK
To drain the DAYBREAK, you must use a garden hose to siphon the water. Place one end of the hose in the DAYBREAK and hold it in front of a
DRAINING THE PUMP |
|
|
After the DAYBREAK |
|
|
is drained (see |
|
|
DRAINING THE DAY- | Pump |
|
BREAK above), the |
| |
|
| |
pump in the spa jet |
|
|
unit should also be |
|
|
drained if the DAY- |
|
|
BREAK will be stored |
| Drain Plug |
for more than thirty |
| |
days, or if it may be |
|
|
exposed to freezing temperatures. |
|
To drain the pump, remove the spa jet unit from the side panels. Be careful not to tear the spa liner. Locate the pump inside the spa jet unit. Remove the indicated bolt from the pump. Tip the spa jet unit slightly, until all the water has drained from the pump. Replace the drain plug.
14