![](/images/new-backgrounds/1222006/2220069x1.webp)
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated with
required for assembly: a phillips screwdriver and two adjustable wrenches (not included).
During assembly, refer to the drawings below to identify the small parts used in assembly.
| Base Leg Nut |
| Console Screw | |
| Flange Nut |
| ||
|
| |||
|
|
| ||
|
|
| Upright Bolt | Base Leg Bolt |
Base Leg Washer | Upright Washer |
| Handrail Bolt | |
|
| |||
|
|
| ||
|
|
|
|
1.Refer to drawing 2 below. Note that the Console Base (52) and the Right Handrail (60) are connected to the treadmill by the Wire Harness (76). During assembly steps 1 through 3, be careful to avoid pulling on or damaging the Wire Harness.
Refer to drawing 1. With the help of a second per- son, carefully lay the treadmill on its side. Position one of the Base Legs (64) on the base of the Upright (59) as shown. Make sure that the Base Leg Pads (67) and the Front Wheel (65) are in the indi- cated positions. Attach the Base Leg with two Base Leg Bolts (69), two Base Leg Washers (70), and two Base Leg Nuts (73).
With the help of a second person, carefully turn the treadmill onto its other side. Assemble the other Base Leg (64) as described above.
With the help of a second person, carefully raise the treadmill to the upright position so the Base Legs (64) are resting flat on the floor.
2.Hold the treadmill firmly with both hands, and lower the treadmill to the floor. To decrease the possibili- ty of injury, bend your legs and keep your back straight.
1
| 65 | 69 |
|
| 70 |
59 | 73 | 67 |
|
| 64 |
73
2
52 76
60
5