3.Refer to the inset drawing. If there is a plastic tie holding the Cage Nut (104) in the Right Handrail (1), remove the plastic tie. Pull 10 to 12 cm (4 to 5 in.) of the Wire Harness (21) out of the Right Upright (11). Feed the Wire Harness up through the bracket on the Right Handrail and out of the indicated hole. If necessary, use needlenose pliers to grip and pull the out of the holes Wire Harness.
Insert the bracket on the Right Handrail (1) into the upper end of the right Upright (11). Hand tighten two Handrail Bolts (105) with Washers (39) into the Upright as shown.
Attach the Left Handrail (41) to the left Upright (11) as described above. Note: There is no wire in the left Upright.
4.Place the Console Base (46) on the Right and Left Handrails (1, 41). Make a loop with the indicated plastic tie and insert the two Wires (21) through the loop. Pull out just enough of the Wires to connect the Wires to the two connectors in the Console Base. Important: Insert the two Wires fully into the connectors. Then, tighten the loop and cut off the excess plastic tie. WARNING: Never disconnect or connect the Wires while the treadmill power cord is plugged in.
Refer to drawing 4b. Thread four Screws (99) into the Left and Right Handrails (1, 41) and the Console Base (46). After all four Screws have been started, tighten the
Screws until they are snug; do not overtighten the Screws.
Refer to step 3. Tighten the four Handrail Bolts (105).
5.Attach the Storage Latch (14) to the left Upright (11) with the two Latch Screws (99). Be careful not to over- tighten the Latch Screws.
3 | 21 |
| |
| 105 | 105 | |
| 39 | ||
| 39 | ||
41 | 1 | ||
| |||
| 11 |
| |
39 | 39 | 11 | |
| |||
105 |
| ||
105 |
| ||
|
| ||
1 |
|
| |
21 |
|
| |
104 |
|
| |
Tie |
| 34 | |
11 |
| ||
|
| ||
4a |
| 46 | |
1 |
| ||
|
| ||
| 21 |
| |
Tie |
|
| |
4b |
| 41 | |
|
| ||
1 |
|
| |
| 46 |
| |
99 |
|
| |
|
| 99 | |
5 |
|
| |
| 11 |
| |
|
| 99 | |
14 |
|
|
6.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat under the treadmill.
6
